Page Comparison

Overview

Renewing a contract is different than an adjustment or extension in that you can set a renewal start date past the current contract's end date, whereas an extension always begins at the current contract's end date. This guide assumes that the proper steps were taken to communicate with the Vendor and Contract Administrator to initiate the renewal process. Follow the instructions below to submit an approval request for a renewal. If an extension to the contract is needed instead follow the Extend a Contract guide.

Conditions for Renewals

• Contract State must be either Active or Expired

• Contract Substate must be either None or Rejected.

Renew a Contract

1. Navigate to the contract to be renewed.
   
   Image Modified
   
   
2. Click the Renew button in the upper right hand corner of the content frame.
   
   Image Modified
   
   
3. If renewal information was filled out previously, but not submitted for approval, it will appear in the dialog box below.
   
   Image Modified
   
   
4. Make sure the Approver is correct. If changes are needed, enter the new individual in the Approval field.
   
   Image Modified
   
   
5. If you choose an option from the Options field, it will automatically populate the Renewal/Extension

1. Date and Renewal/Extension

1. End Date fields as follows:
   1. If the contract is active, the Renewal/Extension

1. 1. Date will populate as the current contract's end date.
   2. If the contract is expired, the Renewal/Extension

1. 1. Date will populate as the current date. 
   2. The Renewal/Extension

1. 1. End Date will populate however long after the Renewal/

1. 1. Extension Date you chose in the Options dropdown.
   
   Image Modified
   
   
2. Otherwise, enter a date into the Renewal/Extension

1. Date and Renewal/Extension

1. End Date fields.
   
   Image Modified
   
   
2. If there

1. are any

1. cost adjustments for the renewal, fill

1. the

1. cost adjustment fields as follows:
   1. Select a value from the Cost

1. 1. Adjustment Type dropdown.
      
      Image Modified
      
      
   2. Enter a value for the Cost

1. 1. Adjustment Percentage or Cost

1. 1. Adjustment Amount. Filling out one will automatically populate the other.
      
      Image Modified
      
      
2. To save the renewal information and not submit for approval, click Save. The contract Substate will change to Awaiting Review.
   
   Image Modified
   
   
3. To submit the renewal for approval, click Submit for Review. The contract Substate will change to Under Review.
   
   Image Modified
   
   
4. Finally, update fields as necessary on the contract record.

1. Click Update at the upper right-hand corner of the content frame to save your changes.
   
   Image Modified

Revision History